KTM Axle Pushers
This small addition to your tool kit can help
save time and expensive damage to you
stock front axle.
DON'T grab that Hammer and Punch first!!
save time and expensive damage to you
stock front axle.
DON'T grab that Hammer and Punch first!!
In your stock KTM LC8 tool kit you should have
a 17mm socket, the same one used on my
Sparkplug wrench. Use this to thread it into the
axle. If you don't, your fingers will work too.
Thread it in a few turns.
950 SE version uses the 10mm socket.
a 17mm socket, the same one used on my
Sparkplug wrench. Use this to thread it into the
axle. If you don't, your fingers will work too.
Thread it in a few turns.
950 SE version uses the 10mm socket.
PUSH or tap on the end of your "T" handle
with a small rock or hammer.
This will save the axle threads from any
damage caused by a punch.
with a small rock or hammer.
This will save the axle threads from any
damage caused by a punch.
If you don't have the 17mm socket, the
end of your "T" wrench will work too.
end of your "T" wrench will work too.
When you reinstall, add some
grease or a small amount of engine
oil off your dipstick if on the trail.
grease or a small amount of engine
oil off your dipstick if on the trail.
Some pullers can make your axle oval when tightened
up. This makes the axle harder to remove.
up. This makes the axle harder to remove.
Available in Orange so it's easy to find in the tool box.
$28 plus shipping
$28 plus shipping
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
 |
-950/990 ADV version (30mm axle)
and
-950 SE version (26mm axle)
Let us know what bike you have.
and
-950 SE version (26mm axle)
Let us know what bike you have.
950/990 ADV shown